Software Programming
if one is programmed, or the first number if no second phone number exists. It will
retry these numbers until the call is answered or the conversation time elapses (see
PBX/Configuration Codes, page 10).
If your phone has two buttons, the top button is Button #1 and the bottom button is
Button #2. If you have a Keypad phone, Button #2
cannot
be programmed to dial an
outside number. This button is used to get a dial tone before using the keypad to
dial.
Entering "#" inserts a four second pause when placed in a dial string.
For example:
• When using 9 to obtain an outside line, enter "9#" and then the number
desired. This allows the phone system to switch to an outside line without
missing dialed digits.
• When dialing pagers or voice mail systems, use "#" in the number string
where a pause is required.
F. Speaker & Microphone Codes
The speaker and microphone turn on automatically when the unit is activated. The
caller will hear dial tone, dialing, and busy signals. You may wish to silence these
call progress tones. You may also wish to activate the silent call in feature by
activating the speaker and microphone when
you
call the
unit
.
Command Function
*5*
Turns on unit speaker & microphone when you call in to the unit. Effective for
that call only.
*78*
Automatically turns on unit speaker & microphone every time you call in to the
unit.
*79*
Cancels the *78* command
(default)
*19*
Makes call progress tones audible
(default)
*20*
Makes call progress tones silent (Mode I only)
If *78* has been programmed, future calls to the unit will begin in communication mode.
To perform any programming, hold the * button down for a full second prior to entering the
guard code. If the phone you are calling from cannot play a tone for 1 second (e.g. a cell
phone), you may need to call from a different phone.
Command Function
*13* …[up to 18 digits]*
Programs the primary number called by Button #1
*23* …[up to 18 digits]*
Programs the secondary number called by Button #1
*80* …[up to 18 digits]*
Programs the primary number called by Button #2
*81* …[up to 18 digits]*
Programs the secondary number called by Button #2
