AOR Series Analog Stations
Installation & Operation Manual
Page
4
of
27
Rev. 1/7/2022
Copyright 2021-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
2. Hardware Installation
Installation should be performed by qualified personnel only in accordance with the National Electrical
Code and other federal, state and local statutes and building codes. Using shielded cable is
recommended to avoid noise, hum, and other
operational
anomalies.
You will need a TS-10 Pin-in-Torx screwdriver or bit to complete this. If you do not own one, you may
purchase one from your local industrial supply store or from Talkaphone. Contact your Talkaphone
distributor for purchasing information.
Talkaphone Model
FM-110
and Model
SM-110
are designed to accommodate the AOR Series Analog
Stations for flush mounting and surface mounting, respectively. Contact your distributor or Talkaphone
for more information.
1. Terminate the red-green pair to the appropriate station port/terminal on the analog AOR Command
Unit (red is ring, green is tip). The red-green pair should route back to a small 2-pin connector
located near center-right on the circuit board (see photo below).
