AOR Series Analog Stations
Installation & Operation Manual
Page
13
of
27
Rev. 1/7/2022
Copyright 2021-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Summary List of Programming Codes
Programming
Code
Then
Enter
Memory Slot
Function Description
0-20 digits
+
#00
Primary autodial phone number for pushbutton
0-20 digits
+
#01
Secondary autodial phone number for pushbutton
0-20 digits
+
#02
Third autodial phone number for pushbutton
0-20 digits
+
#03
Fourth autodial phone number for pushbutton
0-20 digits
+
#04
Fifth autodial phone number for pushbutton
0-20 digits
+
#05
Autodial phone number for central station receiver line
0-20 digits
+
#06
Autodial phone number for central station voice line
0-20 digits
#07
Primary autodial phone number for Auxiliary Input
0-20 digits
#08
Secondary autodial phone number for Auxiliary Input
0-20 digits
#09
Third autodial phone number for Auxiliary Input
6 digits
+
#17
Voice message/other options. For further details, see
Section 6.9, Voice
Message Codes, p.16
[Default 001210]
6 digits
+
#18
Timing/dialing options. For further details, see
Section 6.8,
Timing/Dialing Codes, p.15
[Default 234721]
6 digits
+
#19
Change the security code
[Default 827827 or TAPTAP]
0-20 digits
+
#20
Primary ID number for central station
[Default no ID number set]
0-20 digits
+
#21
Secondary ID number for central station
[Default no ID number set]
6 digits
+
#23
Talk-A-Lert ID number
* *
Add a
*
at any point of the dial string
* #
Add a
#
at any point of the dial string
* 7
Add 4-second pause at any point of the dial string
[Enter No Digits]
+
#00 through #06
Clear autodial phone numbers
* 0
Diagnostic tones to check microphone/speaker operation
* 1
Enable the Talk-A-Lert ID number to be transmitted when the AOR Series
Analog Station auto-answers an inbound call
* 2
Enable the Talk-A-Lert ID number to be transmitted when the remote side
answers the call (i.e. an outbound call)
* 6
Disable
* 1
and
* 2
[Default]
#
Disconnect or terminate
an active outbound call only (i.e. cannot
terminate/disconnect inbound calls or programming mode calls)
# 7
Exit programming mode and disconnect
# # #
Reset to factory defaults
NOTE:
After each programming code, a double-beep indicates the code has been accepted. Four (4) beeps
indicate an error
—re-enter the code again.
