AOR Series Analog Stations
Installation & Operation Manual
Page
9
of
27
Rev. 1/7/2022
Copyright 2021-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
5. Mode Configuration DIP Switches
Mode Configuration DIP Switches #1, 2, and 3
are provided to configure a number of modes as
outlined below.
Mode
Configuration
DIP Switch #
Position
Function Description
1
ON
Pushbutton is used to both place
and
disconnect calls
OFF
Pushbutton is only used to place calls
[Default]
2
ON
Auto-answers inbound calls
[Default]
OFF
Does
NOT
auto-answer inbound calls
3
ON
Normal operation mode
[Default]
OFF
Learn mode - Any inbound calls automatically enter into
programming mode (no security code required).
Use this option if the security code has been lost or forgotten. Any
outbound call will dial Talkaphone Technical Support (see
Section
6.11, Assisted Programming, p.18
IMPORTANT NOTE:
When finished programming, set this switch
back to the
ON
position or else the unit will only call Talkaphone
Technical Support instead of the programmed phone number(s).
