WEBS-ZPS Zone Paging System Instructions
Copyright © 2011 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 6 of 7
Phone 773.539.1100 • Fax 773.539.1241 • info@talkaphone.com • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
V.
Zone Paging System Programming
1. To switch to programming mode, remove the switch lock and place the PROGRAM/RUN switch to
PROGRAM position. In the case of a
WEBS-ZPS
unit without a 7-pin DIP switch (TEL INT SEL) on
the first module, all programming is accomplished through the TRUNK jack on the first module, using
the appropriate installed interface. To simplify initial programming, it is suggested that you change the
interface type to loop start trunk as shown in
Figure 5
and connect a single-line telephone to the
TRUNK jack. Once initial programming is completed, re-select the proper interface type and connect
the access line.
2. The third, fourth, and fifth modules (zone modules) are not changed during programming.
3. Access
the
WEBS-ZPS
system by either going off-hook with a single line telephone connected to the
WEBS-ZPS
or by dialing the paging access number for the telephone system.
Programming Zone Groups
1. Dial the paging access number for your telephone system.
2. The
WEBS-ZPS
will emit 3 beep tones, indicating access to the programming mode.
3. Dial
[*]
followed by the 2-digit number of the zone group (01-32) you want to create. Follow this with
the two-digit numbers of the zones you want to be in the zone group. To save the data press
[#]
.
Example:
If you want to create zone group 7 consisting of zones 2, 3, and 12, you would dial:
[*][0][7][0][2][0][3][1][2][#].
4. When finished programming return the PROGRAM/RUN switch to RUN.
To Erase a Zone Group
1. Dial the paging access number for your telephone system.
2. The
WEBS-ZPS
will emit 3 beep tones, indicating access to the programming mode.
3. Press
[*]
and the 2-digit zone group number you wish to erase and then press
[#]
.
4. When finished programming return the PROGRAM/RUN switch to RUN.
To Disable the 30-Second Paging Time Out and 6-Second VOX Feature
1. Dial the paging access number for your telephone system.
2. The
WEBS-ZPS
will emit 3 beep tones, indicating access to the programming mode.
3. Dial
05000#
4. Dial
0510#
5. If the system accepts the code, you will hear a short double beep. Otherwise if the code is not
accepted, you will hear a busy tone. If the code is not accepted, hang up, re-access the system and
try again.
6. Hang up the phone and place the PROGRAM/RUN switch in the RUN position.
