Setup
You should have received the following items:
TalkingSign™ transmitter
120VAC to 12VDC wall adapter
wire antenna
lapel microphone
owner’s manual
Step 1
Plug antenna wire into antenna (3) and extend out horizontally.
Step 2
Select ‘3m wire’ with antenna selector (2)
Step 3
Connect wall adapter to 12VDC input (6).
Step 4
Plug wall adapter into standard 120 volt outlet.
Step 5
Select desired transmit frequency using slide switch (4) and rotary switch (5). 30 channels are
available from 1400AM to 1690AM. Before choosing a frequency, make sure it is clear by
‘listening’ with an AM radio. Competing with other signals will reduce the range of the
TalkingSign™.
Step 6
Taking care not to touch antenna wire, turn the wire antenna tuning control (1) until the wire
antenna tuning meter (e) shows a maximum reading. Each time you change the broadcast
frequency, or move the antenna, retune for maximum output.
