28
TalkSwitch User Manual
In the “Calibration” section:
After you have configured the lines, it is recommended that you calibrate the
lines. Completing this procedure optimizes your telephone line volume levels for
the Call Bridge and Call Forwarding (with Remote Extensions) features.
Note: Only lines that are detected can be calibrated.
2.3.1.2 Line Hunt Groups
There are a total of 9 Line Hunt Groups for controlling
outbound
call line selections.
These Line Hunt Groups are used by the Local and Remote Extensions, and when
using the Call Bridge feature. Each Hunt Group can support several line choices and
will attempt to grab an available line in the order that they are listed (Lines to hunt)
for that Hunt group.
These settings have no effect on incoming calls.
The default setup:
Hunt Group 9:
selects any available line
Hunt Group 81:
selects Line 1
Hunt Group 82:
selects Line 2
Hunt Group 83:
selects Line 3 (for the TalkSwitch 48 only)
Hunt Group 84:
selects Line 4 (for the TalkSwitch 48 only)
TS-user manual 7th ED v3 Release.qxd 8/27/02 4:56 PM Page 28
