T A L K S W I T C H C O N F I G U R A T I O N
3 3
Under ‘Set Line Hunt Group’, select the lines you wish to add to the Hunt
Group by checking the box next to the line.
2.3.3.7 Automatic Route Selection and Toll Restriction
Automatic Route Selection (ARS) allows outgoing calls to be redirected to
different telephone lines or VoIP trunks and hence network operators based
on the leading digits dialed to access geographical areas, mobile operators or
services. For example, use this feature to block all long distance calls or
redirect long distance calls to VoIP.
Toll Restriction allows calls to be blocked based on the geographical area
code, mobile operator, service number or access code dialed.
The Automatic Route Selection (ARS) table is programmed by the system
administrator with the leading digits of calls to be re-routed or blocked.
TalkSwitch routes outgoing calls through Line Hunt Groups to telephone
lines or VoIP trunks, dialing the outgoing Line Hunt Group access codes “9”
or “81” to “88” or directly when Direct Line access is enabled on an
extension. When ARS is activated for any Line Hunt Group and the caller has
dialed, their dialed digits are compared to the leading digit entries in the
Automatic Route Selection (ARS) table.
Note:
If multiple TalkSwitch units are connected to the LAN,
a check box is enabled, so that outbound calls always hunt
the lines on the unit where the extension is connected. This
minimizes network traffic between units.
