4
W W W.T A L K S W I T C H . C O M
T S - 2 0 0 U S E R G U I D E
SETTING UP YOUR TS-200 PHONE
Before you can start using your TS-200 telephone, you will need to do the following:
1. Configure your line access mode.
2. Set the language display.
3. Enable headset operation if you’re using a headset.
4. Set the date and time.
CONFIGURE THE LINE ACCESS MODE
When you first power up the phone, the display will show DIRECT LINE? with
options YES and NO.
• If this extension is configured so that you don’t need to dial
to place
external calls, then select YES.
• If you dial
before placing external calls, then select NO.
Once set, the phone will automatically adjust redial, speed dial and Caller ID
dialing accordingly.
If the phone doesn’t display the DIRECT LINE? prompt, toggle the PBX/Standard
switch from PBX to Standard back to PBX. The switch is located on the right
side of the phone as shown in the picture. The phone will then prompt you for
direct line selection.
NOTE:
Ensure that the PBX/Standard switch is in the PBX position when you
are done.
PBX Switch
9
9