E V E R Y C A L L C O U N T S
4 1
•
Call Waiting Tone:
When enabled, a tone is played to the user along with Caller ID information to
announce the new call.
•
Call Hold Ringback:
When enabled, the phone rings if the user has taken a 2nd call then terminated
the call with another caller still on hold.
•
Message Waiting Tone:
When enabled, a stutter dial tone is played when first going off-hook and a
new message is waiting. The visual LED notification is always enabled for voicemail notification.
•
Auto Answer:
When enabled, it will automatically activate the speakerphone or headset when an
incoming call is received.
•
Access Code Prefix:
To simplify dialing from the Phonebook or Call Logs, enter a hunt group (9, 81-88)
that you would like the phone to use as aprefix to place calls using the specified hunt group. If direct
line access is enabled for the extension, then leave blank.
•
Call Forwarding:
is not supported directly by the TalkSwitch phone. Call forwarding is configured in
the TalkSwitch system for busy, no answer and DND conditions for the extension.
•
Direct Call (Hotline/Warm-Line):
When used with the TalkSwitch system, the feature is controlled by
the configuration in the software for this extension. No configuration is required.
•
Direct Call:
when enabled, places a call to a predefined destination automatically when the phone
goes off hook.
•
Direct Call Number:
defines the destination for a direct call.
•
Direct Call Timer:
sets a delay timer for Warm-Line operation. The timer specifies the period
before placing a direct call. The timer supports 1 second increments from zero (0) to ten (10)
seconds. For Hotline operation, set the timer to zero (0) seconds.
To modify parameters on the Call Preferences screen:
•
Select the desired parameter and enter or select the new values.
•
When complete, select the
Save
button to save the new values to the phone.
