A D D I N G I P P H O N E S T O T A L K S W I T C H
2 4
•
Pickup any
— Do not select a resource. Press the button or softkey to answer a call from an
outside number ringing any extension. Lights or icons are not used for Pickup keys. Note:
You can also pick up a call by pressing
*9#
.
•
Pickup ext
— Do not select a resource. Press the button or softkey, dial an extension, then
dial
#
(or softkey again) to answer a call from an outside number or extension ringing the
selected extension. Lights or icons are not used for Pickup keys. Note: You can also pick up
a call at a selected extension by pressing
*7
, dialing the extension, then pressing
#
.
•
Intercom page
— Do not select a resource. Press the button or softkey, dial an extension,
then press
#
to page the extension in Intercom mode. The intercom page function can only
page TalkSwitch phones. Lights or icons are not used for Page keys. Note: You can also page
a TalkSwitch phone by pressing
*84
, dialing the extension, then pressing
#
, or the
Dial
key
or softkey.
•
Overhead page
— Do not select a resource. Press the button or softkey to connect to an
attached external PA system. Lights or icons are not used for Page keys. Note: You can also
page the external PA system by pressing
*0#
.
•
Queue (show list)
— Do not select a resource. Press the
Queue
softkey, select a queued call,
then press
Retrieve
to connect to the selected call. This function is only available when
programmed as a function key on supported phone models (e.g. TS-480i).
•
Phone book access
— Select the phone book record two-digit speed dial number as the
resource. Press the button or softkey to place a call using the contact information from the
associated phone book record. When the button is pressed, it will light up for the duration
of the call. This function is available on the TS-350i, TS-450i and TS-550i models.
•
User Defined (phone)
— The button or softkey function is assigned using the phone's
configuration options, and is not assigned using TalkSwitch Management software.
•
None
— The button or softkey is not programmed.
