Tally Dascom 1140
43
8. When you respond with
OK
to set the tear-off position, the printer prompts you to reload
a black marked fanfold form:
Press any key to eject the paper, and load paper with black mark in the Fanfold
Path.
The printer reloads the form. By default the form stops 5.5 inches away from the
printer’s tear-off blade. Press
Next
or
Back
to feed or reverse-feed the paper till the
desired tear-off position is reached. (With the above measured vertical position, the
printer will convert the net paper feeding to the tear-off position relative to the black
mark.) Press OK to confirm the tear-off offset relative to the black mark. Finally, press
Save and Restart
to save new settings and terminate the session.
5.7 Bidirectional Alignment
When wiggling vertical grids appears in tabular reports, you should adjust the Bidirectional
Alignment. The procedures to adjust bi-directional alignment across adjacent line grids:
1. Hold down the
Tear
key while powering on the printer and then release the key when
the print head starts to move. After loading paper, the printer prompts the Printer
Settings.
Printer Settings
[TEAR]=Back, [LF]=Next, [LOAD/EJECT]=OK, [ONLINE]=Exit,
[[LOAD/EJECT]=Save and restart the printer.
System Setup
2. Press the
Next
or
Back
keys to scroll forward or backward the sub-menus till the
printer shows:
Bi-directional Alignment
3. Press OK to go into the Bi-directional Test menu. The printer prompts:
[Bi-direction Alignment]
[TEAR]=-1, [LF]=+1, [LOAD/EJECT]=OK, [ONLINE]=Back,
[[LOAD/EJECT]=Save and restart the printer
20
| | | | | | | | | | | | | | |
| | | | | | | | | | | | | | |
4. Every press on “
+1
” or “
-1
” shifts the second line to the right or left, respectively, relative
to the top line by 1 fine step. After pressing “+1” twice and then “
OK
”, the printer
prompts:
22
| | | | | | | | | | | | | | |
| | | | | | | | | | | | | | |
