Tally Dascom DM-310/320 User Guide V1.0
64
5.3 Clear a Paper Jam
1.
Turn off the power and open the rear
cover.
If the rear cover cannot be opened.
When there is a cutter problem, the printer
may stop with the cutter blade protruding so
that pressing the FEED switch fails to clear the
error. When this happens, restore the cutter
blade manually by inserting a screwdriver into
the hole on the left side surface of the rear
cover and rotating it, then open the cover (the
blade will be restored whether you turn it to
the left or right). Turn the screw driver so that
the projections on both ends of the blade of
the cutter are returned to the back of the
printer (direction shown by the arrow).
2.
Remove
all
the
jammed
paper
(temporarily remove the roll paper that is
installed in the printer).
CAUTION:
When removing the
jammed paper, be careful not to
touch the area around the print
head nor the cutter blade. If you
do you will be burned or cut.
3.
Close the rear cover and turn on the power.
The auto cutter operation will be
initialized and the error cleared.
End of the blade of the cutter
Paper cut bar
Cutter lock clearing screw hole
Rear Cover
Front Cover
Summary of Contents for DM-310
