Tally Dascom DT-210/230 Programming Guide V1.1
- 49 -
(nL + nH × 256)
Maintenance counter [Units]
Hex
Decimal
14
20
Number of lines fed. [Lines]
15
21
Number of head energization. [Times]
32
50
Number of auto cutter operations. [Times].
46
70
Duration of printer operation. [Hours].
[Note]
• Frequent write command executions by an NV memory write command may damage
the NV memory. Therefore, it is recommended to limit writing the commands into the
NV memory to less than 10 times a day.
• If the power is turned off or the printer is reset via an interface while this command is
being executed, the printer may go into an abnormal condition. Do not turn the power
off or do not reset the printer via an interface while this command is being executed.
• While processing this command, the printer may become BUSY while writing the data
to the NV memory and stops receiving data. Therefore, do not transmit data from
the host computer while the printer is BUSY.
ESC 2
[Type]
Line spacing
[Function]
Select default line spacing
[Format]
ASCII
ESC
2
Hex
1B
32
Decimal
27
50
[Description]
Sets the line spacing to approximately 4.23 mm (1/6 inches)
ESC 3 n
[Type]
Line spacing
[Function]
Set line spacing
[Format]
ASCII
ESC 3 n
Hex
1B 33 n
Decimal
27 51 n
[Range]
0 ≤ n ≤ 255
[Default]
Equivalent to approximately 4.23 mm {1/6"}
[Description]
Sets the line spacing to [n × (vertical or horizontal motion unit)]
[Note]
The maximum is 1016 mm {40"}.
Summary of Contents for DT-210
Page 1: ......
