Tally Dascom DT-210/230 User Guide V1.3
66
6.3
Trouble occur during cutting
Trouble
Potential Problem
Solution
Colored stripe in the paper
Cutter abrasion, insufficient
cutting
Replace the cutter
Cutter jam, the movable
cutter cannot move back
Worn gear and worn wheel
abrasion
Replace the worn gear and worn
wheel
Motor burnt
Replace the motor
Paper scraps
Clean the paper scraps on the
transmission system
Insufficient cutting
Cutter edge abrasion, paper
too thick
Replace the cutter
Paper Jam
Thermal printer head over
hear
Reduce the density of printing
Driving too fast
Reduce the printer speed to the limit
of thermal printer head
Wrong paper feeding
position
Put the paper parallel with paper
mount and insert into the space
between the platen roller and the
thermal print head
6.4
Removing Jammed Paper
When a paper jam occurs, never pull out the paper forcibly. Open the roll paper cover and remove
the jammed paper.
When the cover cannot be opened, follow the steps below to remove the jammed paper.
Printhead may be hot, please do not touch!
1.
Turn off the printer.
Summary of Contents for DT-210
