Tally Dascom DT-210/230 User Guide V1.3
64
5.2
Hexadecimal Dumping Mode
This function is to print out all received data in hexadecimal numbers. If printing cannot occur correctly,
this function allows checking whether or not the printer is receiving data correctly.
Follow the steps below to run this mode.
1.
Open the roll paper cover.
2.
While pressing the FEED button, turn on the printer.
3.
Close the roll paper cover.
The printer starts printing “HEX DUMP PRINT MODE” followed by the received data printed in
hexadecimal numbers and some characters.
CAUTION!
The printer prints “.” if there is no characters corresponding to data.
During hexadecimal dump, functions except some command will be disabled.
If print data does not cover a line, press the FEED switch to print the line.
Printing example:
Hexadecimal Dump
To terminate hexadecimal dump,
press FEED button three times.
1B 21 00 1B 26 02 40 40 1B 69 . ! . . & . @@ . i
1B 25 01 1B 63 34 00 1B 30 31 . % . . c 4 . . 0 1
41 42 43 44 45 46 47 48 49 4A A B C D E F G H I J
*** completed ***
Turn off the printer or press the FEED button three times to return to the normal mode.
Summary of Contents for DT-210
