4.2.5
Setting the Paphand
function
The Paphand group of menus improves the possibilities for the trouble-free printing
of paper with properties likely to cause problems (perforations, carrier strips, etc.) or
poor quality paper.
Put the printer into Testmode and change to the parameter group Paphand CX-bid
by pressing the key Next three times. Select the Paphand menu (the abbreviation
stands for ”paper handling”).
4.2.5.1
Head up
Select the Head up menu.
Possible settings: On/Off
Default setting:
Off
If the parameter is set to On, the print head gap increases during form feed and line
feed four lines before and after the perforation on the form (protected zone). The print
head gap is always increased during form feeding past the perforation even when feed-
ing takes place outside the protected zone.
Confirm your settings by pressing the key Set.
4.2.5.2
Pagewid
Select the Pagewid menu (stands for page width).
Possible settings: From 20 to 136 in 1/10
inch steps
Default setting:
136/10 inch
(136 characters at
10 characters/inch)
This parameter determines the actual paper width. If Head up = On, the print head
moves to the calculated centre of the paper during the time the paper is moving in
the protected zone. If Rightzo = On (see below), the print head moves out of the
perforation zone on the right as long as the paper is being transported.
Confirm your settings with the key Set and press the key Next to access the next
group of parameters.
4.2.5.3
Leftzon
Select the Leftzon menu (stands for left zone).
Possible settings: On/Off
Default setting:
Off
If the parameter is On, the print head moves out of the perforation zone (area) on
the left as long as the paper is being transported. The Pagewid setting has no in-
fluence (see above).
Confirm your settings with the key Set.
Head up=Off *
Online
Setup
Set < > Exit
Pagewid=136/10"*
Online
Setup
Set < > Exit
Leftzon=Off *
Online
Setup
Set < > Exit
Testmode
Test functions, troubleshooting and maintenance
4-6
Summary of Contents for T2040
