5.11
Replacing the
printhead cable
—
Remove the casing parts (see section 5.1).
—
Remove the main controller board (incl. casing, see section 5.4.1).
—
Remove the AGA and timing station sensor (see section 5.8 and 5.9).
—
Remove the ribbon drive (see section 5.12)
—
Remove the carriage motor (see section 5.14).
—
Move the carriage to the left.
—
Remove the transparent cable holder A.
—
Use a screwdriver to release the cable holder B from the two noses and move it to
the left.
—
Remove the cable holder C in the carriage.
—
Remove the printhead cable D.
—
Take care of the isolation shield E.
D
A
B
C
E
Instructions for disassembly and assembly
Replacing the printhead cable
5-21
Summary of Contents for T2150 SprintPro
