User guide
2T model
47
2T model
Introduction
This section describes how to handle the rear tractor (paper feed
from the rear), which is only available and permanently installed in
the 2T printer model in addition to the primary tractor (paper feed
from the front).
The
Paperway
parameter group in the menu of the 2T model differs
from the one of the standard printer as follows:
The permanently installed rear tractor is identified as “Trac3”
in the menu. “Trac2“ in the menu refers to the optional tractor
which can be installed both on the standard printer and the 2T
model. The optional tractor 2 can be installed by the user.
Rear tractor paper path
For information on the printable length and width of the forms
and other specifications, refer to
Paper specifications
, page 128.
The 2T model cannot accommodate an additional automatic
single sheet feeder, which is available for some printer models.
8
Standard printer
2T printer
Paperway
Tractor1 (standard, front)
Tractor2 (optional, front)
Paperway
Tractor1 (standard, front)
Tractor2 (optional, front)
Tractor3 (standard, rear)
Tractor 1
Tractor 2
Tractor 3
Summary of Contents for 2365
