Operator Manual
S–4
Power Supply
The printer requires single phase, 47 to 63 Hz. 90 to 264 VAC input power.
The printer’s universal power supply automatically adjusts to the correct
values. A fuse is provided to interrupt power to the power supply. The follow-
ing table gives typical current values.
Table S–2. Power Requirements
External Power
Current/Wattage Requirements @ Nominal
Voltage
Supply
AC Volts Freq.
Average
Peak
Average
Average
(RMS)
(Hz)
Operating
Operating
Idle (<5 min.)
Idle (>5 min.)
110
50
2.0 A/215 W
5.5 A/600 W
0.5 A/55 W
0.3 A/30 W
110
60
2.0 A/215W
5.5 A/600W
0.5 A/55W
0.3 A/30 W
220
50
1.0 A/215W
2.8 A/600W
0.3 A/55W
0.2 A/30W
Preventive Maintenance
This printer is designed to eliminate the requirement of scheduled mainte-
nance procedures, such as alignment, adjustment, or lubrication. Preventive
maintenance is limited to periodic cleaning. Dust and paper fibers should be
removed periodically with a soft cloth and brush or a vacuum cleaner. Clean
the printer case with a damp cloth and soapy water. DO NOT use any abra-
sive cleaners or solvents, as they will damage the case.
Safety
Personnel hazard areas have restricted access with appropriate warning
labels. Catastrophic equipment failures are inhibited with protective functions
in major areas of overload potential.
Cooling System
Cooling system malfunctions are detected and a failure will result in shuttle
motion, paper motion, and printing functions being inhibited. The malfunction
will be reported on the control panel display.
Summary of Contents for T6212
