background image

USER MANUAL

Petrol Line Trimmer

W ARNING   PLEASE READ

For your own safety please read this manual before attempting to operate your new unit. Failure to follow
instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your trimmer
before each use.

M O D E L NO. AT33451

9096-3345xx

SAFETY

OPERATION

MAINTENANCE

W A R R A N T Y INFORMATION

AU

W orn Bump Head

Trimming line.

Spark Plugs.

Carburetor Tune-ups.

Lubricants.

Starter Assemblies.

Engine Tune-ups.

Filters.

LINE TRIMMER WA R R A N T Y

The benefits conferred by this warranty are in addition to all other conditions and warranties in respect of
this product which the consumer may have taken under the Trade Practices Act 1974 or by any legislation
of a State or Territory of Australia. This product is warranted by Talon Tools Australia (ABN 12 099 520
939)(the  Company ) to be free from defects in material and workmanship for a period of 24 months from
the date of original purchase. The Company during the period of the warranty, will at its option, and sub-
ject to the conditions stated herein, repair or replace without charge this product or any component part,
which upon examination by an Authorised Service Agent or by the Company is found to be defective.

W arranty conditions

This warranty will not apply:
(i)  where this product has been subjected to misuse, abuse, accident or want of care;

 

(ii) where this product has been used for a purpose for which it was not designed or is not suited; 
(iii) where the service of this product has been undertaken by a person not authorised by the Company
to carry out such work or where parts that have not been approved by the Company have been used;  
(iv) where this product has  been used for industrial or commercial purposes.

 

Should service become necessary during the warranty period, the purchaser should contact an Authorised
Service Agent or the Company. In order to obtain warranty service, the purchaser must present the store
receipt showing the name of the retailer and the date of purchase together with a completed Warranty
Card. The period of the warranty begins from the original date of purchase, notwithstanding any  subse-
quent repair or parts replacement. No additional warranty or guarantee other than set out in this document,
whether written or verbal, is authorised to be made on the Company’s behalf. The purchaser shall be
responsible for delivery or causing the product to be delivered to the Company or the Authorised Service
Agent and  the purchaser shall be responsible for all charges in connection with re-delivery of the product
and/or the delivery of parts. Damage in transit is not covered by this warranty and purchasers should
remove from the product any liquids (if applicable) before sending and pack the product securely to pre-
vent damage.

W arranty exclusions

Normal wear parts or components are subject to separate terms as follows: Normal wear parts, compo-
nents or service required when performing normal and regular maintenance of this product are not covered
by warranty unless it is found to be defective by an Authorised Service Agent or by the Company. Normal
wear parts include, but are not limited to:

Returns based on the above listed normal wear parts will not be accepted under this warranty as they
are considered consumable items and are at the expense of the purchaser.

2

Summary of Contents for AT33451







Reviews: