57
①
Recording
The Recording storage is managed in Direct. The Recording storage stores data on the hard disk in the real time.
Five commands can be executed. Depending on the S/W status, however, some commands cannot be executed.
New
Returns the status of the selected storage device to New; if this command is executed,
the selected storage device will be moved to the
{New}
storage device manager.
※
Physical states supporting the execution of the commands above includes Healthy and
Warning. In fault state, however, no command can be executed.
②
Backup
The backup storage is managed in Backup. Backup storages are not used to store data; rather, they a
re only used to back up the data. The user can execute only the
{New}
command.
Depending on the storage type, the storage is used only for (Recording) or (Backup) purposes.
③
New
All storages, initially detected are managed in
{New}
. All initially detected storages are displayed as N
ew and can be changed into Recording storage or Backup Storage.
Recording-Format
Changes the selected storage into a dedicated recording storage.
Backup-Format
Changes the selected storage into a backup storage.
In
{New}
, At least, one storage shall be selected as a dedicated storage. Otherwise, the data
cannot be stored in the real time.
(2)Composition of the local storage device
※
There are three software status types.
Active
Connected to storage or backup device; currently saving the data.
Online
Only connected to storage or backup device.
Offline
Not connected to storage or backup device.
※
There are three hardware status types.
Healthy
Connected to storage or backup device; functions normally.
Warning
Connected to storage or backup device, but error was detected; in this case, data
storing or backup cannot be made (for more information, see the description below).
Fault
Not connected to storage or backup device; cannot perform data saving or backup.
1.
Fault State
: The storage device is completely damaged, and none of the S/W operations
can be performed. The fault state is not related to a DVR problem. The DVR has detected the
fault and stopped the recording.
2.
Warning State
: The storage device has a physical error that can be corrected by the storage
device or by the DVR. If the error is not taken care of, however, the storage device is likely to
be damaged (and shift to fault state). Backing up data in the corresponding storage device
and replacing the device with a normal one are strongly recommended.
3. If there is an active storage device with a warning or a fault, a message is displayed on the
upper left part of the screen.
