Gardner Denver Oy
P.O.Box 516
FIN-33101 Tampere
Finland
Declaration of Incorporation of Tempests
Declaration of Incorporation
(Machinery Directive 2006/42/EC, part B, Annex II) of Tempests
Type: Oil-Flooded Screw Compressor (called “Tempest” in the following text)
This tempest was
manufactured from:
Gardner Denver Oy
P.O.Box 516
FIN-33101 Tampere
Finland
The tempest concerned is an integrated oil separation system, type: T3, T6, T12, T25. The air end
name plate shows the model, the part number and the serial number of the tempest This tempest is
allowed to compress air and separately specified gases. The maximum allowed operational
temperature is 120°C.
The relevant technical documentation is compiled in accordance with part B of Annex VII of the
Machinery Directive. All the relevant information of the tempest will be transmitted, in writing, in
response to a reasoned request by the national authorities. This shall be done without prejudice to the
intellectual property rights of the manufacturer of the tempest
Documenting unit:
Gardner Denver Oy, Tampere
Engineering Manager, sustaining: Harri Väänänen
The following essential health and safety requirements of Directive 2006/42/EC, Annex I, are applied
and fulfilled:
•
Principles of safety integration:
The incorporation of the tempest in the compressor shall be carried out only by qualified
personnel. Qualified personnel is, as a general rule, The Gardner Denver Service personnel or the
Service personnel authorized by Gardner Denver. The Service personnel should wear appropriate
clothing and eye protection during the assembly of the tempest into the compressor. Safety
footwear and safety glasses should be compulsory in all workshops. Safety helmets must be worn
if there is any risk of falling objects. Gloves are recommended.
The tempest was tested before delivery according to PED 2014/68/EU.
•
Materials and product:
The tempest is essentially made of cast iron. Remainder of mineral compressor oil (used in test
run) could be inside the tempest.
•
Handling:
The packaging of the tempest is done for safe transportation with a minimized risk of damaging
during transportation. The installation and commissioning of the tempest should be done within 3
months after delivery. If the tempest should be stored over a long time period, please contact
authorized distributor of Gardner Denver for appropriate preservation.
