tams elektronik
WD-34 | WD-34.2 | WD-34.M
English
Checking the package contents
Please make sure that your package contains:
one kit WD-34, containing the components listed in the parts list and
one PCB or
one ready-built module WD-34, WD-34.2 or WD-34.M or
one ready-built module WD-34, WD-34.2 or WD-34.M in a housing
(complete unit)
WD-34 only: one jumper for programming the address
a CD (containing the manual and further information)
Required materials
For assembling the kit you need:
an electronic soldering iron (max. 30 Watt) or a regulated soldering
iron with a fine tip and a soldering iron stand,
a tip-cleaning sponge,
a heat-resistant mat,
a small side cutter and wire stripper,
as necessary a pair of tweezers and long nose pliers,
electronic tin solder (0,5 mm. diameter).
In order to connect the module you need wire. Recommended
diameters: > 0,25 mm² for all connections.
WD-34.2 only: If you want to display problems occuring when switching
coil driven turnouts with limit stop, you need a LED. A series resistor ist
not required.
WD-34 and WD-34.2 only: When using motor-run turnouts, you need
an additional adapter AMW:
with WD-34: AMW-2 (item-no. 72-00086)
with WD-34.2: AMW-1 (item-no. 72-00076).
Page 5
Summary of Contents for 43-02345
Page 40: ...t a m s e l e k t r o n i k ...
