tams elektronik
Multi-Timer
English
For the connection to the switching inputs you need:
for use as a time switch or a pulse delay (operation mode 1 or 2):
four push buttons, e.g. item no. 84-5212x, x=1..5 (or circuits to
release a switching pulse);
for use as a random switch (operation mode 3):
four switches, e.g. item no. 84-51510 (or comparable circuits);
for use as a start-brake-stopover switch (operation mode 4):
one switch, e.g. item no. 84-51510 (or a circuit to switch over the
signal);
one reed kontact (e.g. item no. 84-53110) or Hall sensor (e.g. item
no. 84-53210) in combination with a magnet (e.g. item no. 84-
53990)
or a photoelectric barrier or similar for initiating of braking;
one push-button (e.g. item no. 84-5212x, x=1..5) or switch (e.g.
item no. 84-51510) to extend the duration of stay manyually.
2. Safety instructions
Mechanical hazards
Cut wires can have sharp ends and can cause serious injuries. Watch
out for sharp edges when you pick up the PCB.
Visibly damaged parts can cause unpredictable danger. Do not use
damaged parts: recycle and replace them with new ones.
Electrical hazards
Touching powered, live components,
touching conducting components which are live due to malfunction,
short circuits and connecting the circuit to another voltage than
specified,
impermissibly high humidity and condensation build up
can cause serious injury due to electrical shock. Take the following
precautions to prevent this danger:
Page 5
