LD-G-11 / LD-W-11
English
Page 35
Lighting
The front and back lighting can be switched on and off according to the
direction of travel from the central unit via the function "function"("f0" /
"Licht") .
CV programming
Setting the address, the driving characteristics (starting and maximum
velocity, acceleration and brake delay) and the velocity characteristic as
well as adjusting the decoder to the particular locomotive motor (motor
frequency, voltage for change of direction, load control parameters) is
done by programming the configuration variables (= CV). The CV
programming has been laid down for DCC decoders in the NMRA
guidelines. The CV programming for this Motorola decoder has been
developed following these guidelines, but differs in some points,
according to the differences between both formats. In particular
programming the decoder on a DCC programming-track is not possible.
Online programming
Alternatively to the CV programming it is possible to program the
address and the driving characteristics "online". This means:
§
Right after starting the programming mode your can enter the new
address and directly save it.
§
While programming the driving characteristics (starting and
maximum velocity, acceleration and brake delay) the locomotive is
running. By operating the speed knob the driving characteristics are
altered. As soon as these are set as desired, they can be saved
directly (online).
Restrictions in Motorola I format
The auxiliary functions F3 (switching on and off the acceleration and
brake delay) and F4 (switching on and off the shunting gear) are not
available in Motorola I format. Programming the decoder can only be
done via CV programming.