English
LD-G-11 / LD-W-11
Page 38
!
Mounting the locomotive decoder
Before mounting the decoder check if the locomotive motor´s current is
below the maximum permissible value of 1.000 mA. If it is above 1.000
mA the decoder is not suitable for mounting in this locomotive. It would
be damaged when put into operation.
Connecting the motor
Open the locomotive housing. Locate the position for the decoder.
Disconnect the motor from the rail current collector or the change-over
switch from the motor and rails if you have a locomotive with electronic
change-over switch. The change-over switch is no longer necessary,
you can remove it.
Caution:
The interference suppression devices mounted to the motor or the
connecting wire must not be removed! Motor and interference
suppression devices are one unit. If even one part is removed, it can
cause extreme interference!
Follow the connections diagrams (fig. 1 and 2)!
Solder the connection to the slider at point X1, and the connection to
the housing to point X7. These two connections can be exchanged
without effecting functionality.
Solder the connections to the motor at the points X9 and X10 (LD-G-11)
or at the points X8, X9 and X10 (LD-W-1). In case the locomotive´s
direction of motion does not match the direction of motion set at the
central unit you should swap the connections at the points X9 and X10.
Connecting the lighting
Before connecting the lighting check if the current is below the
maximum permissible value of 100 mA. If lightings or other accessories
with a current of more than 100 mA are connected the decoder will be
damaged when put into operation.
Follow the connections diagrams (fig. 1, 2 and 3)!
