LD-G-11 / LD-W-11
English
Page 41
Programming the locomotive decoder
With the most digital control units supporting the Motorola II format
(e.g. Tams MasterControl, Märklin* Control Unit, Uhlenbrock*
Intellibox) you can choose between two methods of programming after
having started the programming mode:
1.
CV programming
2.
Online programming
With the Central Station or the Mobile Station of Märklin* you can
program the address, the maximum speed and the acceleration and
brake delay. Select the article no. 29750 from the locomotive database
and program the decoder as described for this article in the Central
Station´s or Mobile Station´s manual.
Starting the programming mode
Put the locomotive on a track oval. If you want to program the decoder
via CV programming it is sufficient to put the locomotive on a track
section. Please note: You must connect the track oval or track section
to the control unit´s track output and not to control unit´s output for
the DCC programming track
Reset the central unit (by simultaneously pushing the buttons "stop"
and "go" for some time) or quickly switch f the central unit on and off.
First enter the current address or the address "80" (e.g. if you do not know
the current address). Manufacturers setting is "78". Set all functions
(function, f1 to f4) to "off".
Push the "stop" button at the central unit. Next, operate the direction
switch and hold it in that position while briefly pushing the "go" button.
As soon as the lamps of the locomotive flash (after approx. 2 seconds)
the decoder is in the programming mode and you an release the
direction switch. Now you can programm the decoder either by setting
the configuration variables (CV) or "online".
