5
MAIN Switch:
Used for switching power source to the Tester.
Panel Sheet Switch:
Consists of START, COOL, RESET switches as well as switches for changing test
parameters.
Display:
Displays test status and result as well as test parameters.
Flash Detector:
Detects flash by monitoring the change in temperature before and after the ignition
source application.
Temperature Sensor:
Senses specimen temperature.
Needle Valve for Test Flame:
Adjusts test flame size.
Windscreen:
Shields to insure flame integrity during test.
Test Cover Release Button:
Release from lock of arm.
Arm:
Lift this arm up and hold the handle when you set the test cup.
Heater Output Indicator:
Blinks when the heater is turned on.
Electric Ignitor Terminal:
Push the center of this terminal to release the Electric Ignitor wires.
Electric Ignitor:
Ignitor uses a platinum coil. It will be as a pilot when “Gas ignition model”, and as a
Ignition source when “Electric ignition model”.
Stove Section:
Houses the heater block assembly for specimen heating inside.
Thermofuse:
Detects blaze up of specimen.
Flame Size Comparison Bead:
Adjust the test flame to the size of this bead.
