(7)
Transmitted Data
The data consists of ASCII coded 39 characters. It starts with “STX” and ends with
“ETX”.
STX
A S P
5 0 1
CR
LF
0 0 0 0 0 1
CR LF
0 6 8 . 7
CR LF
0 6 8 . 3
CR
LF
CR LF
ETX
Instrument No.:
The first 4 characters represent the model; last 2 the serial
number.
Test No.:
A six-digit number that is increased one by one as a test is
executed properly.
Softening Point:
The number is a 4-digit number including 1 digit after decimal
point.
In case of the following situation, this number is replaced by
character strings:
The safety shut off temperature was reached, or trouble has
been found.
“OVER_” (4 letters plus 1 space)
Reserve:
Normally this column is blank.
In case when some trouble has been found, this number is
replaced by character strings:
“TRBL_” (4 letters plus 1 space)
(8)
Operation
The tester automatically transmits data as long as it is connected to a computer as
described above; no other operation is necessary unless the baud rate needs to be
changed. Since the tester is a stand-alone device, whether it is connected to a
computer does not make any difference in its operation.
Instrument No. (6 ltrs)
Test No. (6 ltrs)
Reserve ( 5 ltrs)
Softening Point, Left (5 ltrs)
Softening Point, Right (5 ltrs)
