9
G
B
F
R
E
S
Installation
of
cutting
blade
(Fig.
12)
Fig. 12
When installing a cutting blade, make sure that
there are no cracks or any damage in it and that the
cutting edges are facing the correct direction.
Align the notch hole of the cutter holder with the
hole on the gear case (Top the gear case) and insert
the Allen wrench to stop turning. Turn the
fi
xing nut
clockwise and remove the
fi
xing nut, cutter holder
cap, and toothed lock washers.
The installation of the cutting blade is as follows:
insert the Allen wrench into the notch hole of
the cutter holder and the hole on the gear case.
Then, install the cutting blade (check the installing
direction, as referring to Fig. 14), the cutter holder
cap and toothed lock washers onto the cutter holder
in this order. Finally, tighten the
fi
xing nut securely
by turning counterclockwise with the Combi box
spanner. (Fig. 12)
Fig. 14
CAUTION
●
When
installing
the
cutting
blade,
set
its
center
hole
to
the
convex
part
of
the
cutter
holder
and
hold
it
with
the
concave
surface
of
the
cutter
holder
cap.
Then,
tighten
the
fi
nut
to
prevent
the
cutting
blade
from
being
eccentric.
(Fig.
12)
After
installing
the
cutting
blade,
be
sure
to
remove
the
Allen
wrench
and
Combi
box
spanner.
●
Before
operation,
make
sure
the
blade
has
been
properly
installed.
●
Cutter
holder
cap
under
a
cutting
blade,
check
it
for
wear
or
cracks
before
operation.
If
any
damage
or
wear
is
found,
replace
it,
as
it
is
an
article
of
consumption.
Fig. 13
NOTE
The blade must be retained with a new cotter pin
each time installed. (Fig. 12)
Installation
of
nylon
head
(Fig.
15)
Attach cutter holder (11) to the gear case. Insert an
Allen wrench into the hole in the gear case to attach
winding protector (12) and attach nylon head (13) by
turning it clockwise.
11
12
13
Fig. 15
NOTE
Since cutter holder cap is not used here, keep it
for next metal blade use.
000Book̲TCG40EAS(P)̲̲US.indb 9
000Book̲TCG40EAS(P)̲̲US.indb 9
2009/11/27 17:15:49
2009/11/27 17:15:49
