10
English
Starting
CAUTION
Before starting, make sure the cutting attachment
does not touch anything.
1. Set ignition switch (29) to ON position. (Fig. 17)
29
30
Fig. 17
* Push priming bulb (31) several times so that fuel
fl
ows through return pipe. (Fig. 18)
31
Fig. 18
2. Set choke lever (51) to CLOSED position (A).
(Fig. 19)
51
Fig. 19
3. Pull recoil starter briskly, taking care to keep the
handle in your grasp and not allowing it to snap back.
(Fig. 20)
Fig. 20
4. When you hear the engine want to start, return choke
lever to RUN position (open) (B). Then pull recoil
starter briskly again.
NOTE
If engine does not start, repeat procedures from 2
to 5.
5. Then allow the engine about 2 – 3 minutes to warm
up before subjecting it to any load.
Stopping (Fig. 21)
Decrease engine speed and run at an idle for a few
minutes, then turn o
ff
ignition switch (29).
For models with an engine ignition switch, keep the
ignition switch pressed until the engine comes to a
complete stop.
29
30
Fig. 21
WARNING
A cutting attachment can injure while it continues
to spin after the engine is stopped or power control
is released. When the unit is turned o
ff
, make sure
the cutting attachment has stopped before the unit
is set down.
SAFE OPERATION
CAUTION
○
Always wear gloves during operation or maintenance.
○
Review the area to be trimmed. Look for hazards
that could contribute to unsafe conditions. DO NOT
operate unit if any wires (power, telephone, cable,
etc.) are closer than 50 feet (15 m) to any part of the
operator or unit. (Fig. 22)
000Book̲TCS27EPAP(S)̲Eng.indb 10
000Book̲TCS27EPAP(S)̲Eng.indb 10
2014/06/04 15:30:02
2014/06/04 15:30:02
