4
English
WARNINGS
AND
SAFETY
INSTRUCTIONS
Operator
safety
○
Always wear a safety face shield or goggles.
○
Gloves should be used when sharpening chain.
○
Always wear safety protective equipment such as jacket,
trousers, gloves, helmet, boots with steel toe-caps and non-slip
soles whenever you use a chain saw. For working in trees the
safety boots must be suitable for climbing techniques. Do not
wear loose clothing, jewelry, short pants, sandals or go barefoot.
Secure hair so it is above shoulder length.
○
Do not operate this tool when you are tired, ill or under the
in
fl
uence of alcohol, drugs or medication.
○
Never let a child or inexperienced person operate the machine.
○
Wear hearing protection. Pay attention to your surroundings.
Be aware of any bystanders who may be signaling a problem.
Remove safety equipment immediately upon shutting o
ff
engine.
○
Wear head protection.
○
Never start or run the engine inside a closed room or building.
Breathing exhaust fumes can kill.
○
For respiratory protection, wear a protection mask while emitting
the chain oil mist and dust from sawdust.
○
Keep handles free of oil and fuel.
○
Keep hands away from cutting equipment.
○
Do not grab or hold the unit by the cutting equipment.
○
When the unit turned o
ff
, make sure the cutting attachment has
stopped before the unit is set down.
○
When operation is prolonged, take a break from time to time
so that you may avoid possible Hand-Arm Vibration Syndrome
(HAVS) which is caused by vibration.
○
The operator must obey the local regulations of cutting area.
WARNING
○
Antivibration systems do not guarantee that you will not sustain
Hand-Arm Vibration Syndrome or carpal tunnel syndrome.
Therefore, continual end regular users should monitor closely
the condition of their hands and
fi
ngers. If any of the above
symptoms appear, seek medical advice immediately.
○
Long or continuous exposure to high noise levels may cause
permanent hearing impairment. Always wear approved hearing
protection when operating a unit/machine.
○
If you are using any medical electric/electronic devices such
as a pacemaker, consult your physician as well as the device
manufacturer prior to operating any power equipment.
Unit/machine
safety
○
Inspect the entire unit/machine before each use. Replace
damaged parts. Check for fuel leaks and make sure all fasteners
are in place and securely tightened.
○
Replace parts that are cracked, chipped or damaged in any way
before using the unit/machine.
○
Make sure the side case is properly attached.
○
Keep others away when making carburetor adjustments.
○
Use only accessories as recommended for this unit/machine by
the manufacturer.
○
Never let the chain strike any obstacle. If the chain makes
contact, the machine should be stopped and checked carefully.
○
Make sure the automatic oiler is working. Keep the oil tank
fi
lled
with clean oil. Never let chain run dry on the bar.
○
All chain saw service, other than the items listed in the
operator
ʼ
s/ owner
ʼ
s manual, should be performed by competent
chain-saw service personnel. (For example, if improper tools are
used to remove the
fl
ywheel or if an improper tool is used to hold
the
fl
ywheel in order to remove the clutch, structural damage
to the
fl
ywheel could occur and could subsequently cause the
fl
ywheel to burst.)
WARNING
○
Never modify the unit/machine in any way. Do not use your unit/
machine for any job except that for which it is intended.
○
Never use chain saw without any safety equipment or that has
faulty safety equipment. It could result in serious personal injury.
○
Using guide bar/chain other than recommended by the
manufacturer which are not approved, could result in a high risk
of personal accidents or injury.
Fuel
safety
○
Mix and pour fuel outdoors and where there are no sparks or
fl
ames.
○
Use a container approved for fuel.
○
Do not smoke or allow smoking near fuel or the unit/machine or
while using the unit/machine.
○
Wipe up all fuel spills before starting engine.
○
Move at least 3 m away from fueling site before starting engine.
○
Stop engine before removing fuel cap.
○
Empty the fuel tank before storing the unit/machine. It is
recommended that the fuel be emptied after each use. If fuel is
left in the tank, store so fuel will not leak.
○
Store unit/machine and fuel in area where fuel vapors cannot
reach sparks or open
fl
ames from water heaters, electric motors
or switches, furnaces, etc.
WARNING
Fuel is easy to ignite or get explosion or inhale fumes, so that pay
special attention when handling or
fi
lling fuel.
Cutting
safety
○
Do not cut any material other than wood or wooden objects.
○
For respiratory protection, wear an aerosol protection mask
when cutting the wood after insecticide has been applied.
○
Keep others including children, animals, bystanders and helpers
outside the hazard zone. Stop the engine immediately if you are
approached.
○
Hold the unit/machine
fi
rmly with the right hand on the rear
handle and the left hand on the front handle.
○
Keep
fi
rm footing and balance. Do not over-reach.
○
Keep all parts of your body away from the mu
ffl
er and cutting
attachment when the engine is running.
○
Keep Bar/Chain below waist level.
○
Before felling a tree, the operator must be accustomed to the
sawing techniques of the chain saw.
○
Be sure to pre-plan a safe exit from a failing tree.
○
While cutting, hold saw
fi
rmly with both hands with thumb
fi
rmly
locked around front handle, and stand with feet well balanced
and your body balanced.
○
Stand to the side of the saw when cutting - never directly behind
it.
○
Always keep the spiked bumper face to a tree, because the
chain may suddenly be drawn into a tree, if so equipped.
○
When completing a cut, be ready to hold up the units as it breaks
into clear, so it will not follow through and cut your legs, feet or
body, or contact an obstruction.
○
Be alert against kickback (when saw kicks up and back at
operator). Never cut with the nose of the bar.
○
When relocating to a new work area, be sure to shut o
ff
the
machine and ensure that all cutting attachments are stopped.
○
Never place the machine on the ground when running.
○
Always ensure that the engine is shut o
ff
and any cutting
attachments have completely stopped before clearing debris or
removing grass from the cutting attachment.
○
Always carry a
fi
rst-aid kit when operating any power equipment.
○
Never start or run the engine inside a closed room or building
and/or near the in
fl
ammable liquid. Breathing exhaust fumes
can kill.
Maintenance
safety
○
Maintain the unit/machine according to recommended
procedures.
○
Disconnect the spark plug before performing maintenance
except for carburetor adjustments.
○
Keep others away when making carburetor adjustments.
○
Use only genuine Tanaka replacement parts as recommended
by the manufacturer.
CAUTION
Do not disassemble the recoil starter. You may get a possibility
of personal injury with recoil spring.
000Book̲TCS40EA̲US.indb 4
000Book̲TCS40EA̲US.indb 4
2010/09/01 16:48:18
2010/09/01 16:48:18
