13
Tanco Autowrap 404 EH
Operators manual
6.0 ADJUSTMENT
/ OPERATING.
6.1 SUPPORT
ROLLERS.
Place the bale you want to wrap on top of the rollers. Move the support rollers as tight to the bale
as possible. Make sure that the bale is in center of the rollers.
6.2
HEIGHT ADJUSTMENT OF
DISPENSER.
The Dispenser can be placed in different positions. Disconnect the locking bolt, and adjust the
pre-stretcher so that the plastic hits in the middle of the bale. Replace the locking bolt and the
splint.
6.3
Operating the RDS control box
See chapter 8
6.4
REVOLUTION SPEED OF TURNTABLE.
Start the machine by operating the lever inside the tractor. All 404’s are equipped with an
adjustable valve on the outlet from the main valve block to the motor. Screw in to reduce
turntable speed. Adjust this until the turntable speed is approx. 22 revolutions per minute (Just
below 3 seconds per revolution) and lock the knob in position by tightening the allen-headed
screw in it.
6.5 OVERLAP.
To control the overlap, stop the machine after a few turns. Use a marker to mark a line on the
middle of the film wrapped on the bale. By the next turn this line should just be covered. It is now
possible to use ether the 500mm, 360mm or 250mm film on the MINI WRAP 404EH. The
machine is generally delivered set up for use with the 360mm film. Tanco recommend this size
of film for best results.
If using 250mm or 500 mm film, a special set of sprockets need to be fitted to the turntable
(inside the large chain guard) to maintain correct bale indexing speed. See parts books or contact
your dealer for advice. The chains from the turntable’s main shaft must be lengthened or
shortened as required to ensure correct chain tension. Note that these are twin sprockets. Fit
chain to larger sprocket for 250 mm film and on smaller for 500 mm film.
