18
Tanco Autowrap 404 EH
Operators manual
8.2.5 The Display Menu
The Display menu is divided into 3 sections. At the top level are the settings used during the daily work with the
machine – i.e. Store totals and No. of Wraps.
The Operator Setup’ section enables the operator to perform adjustments to the machine operation – e.g. time
duration and time delay settings during the automatic cycle.
The ‘Technician Setup’ menu is not normally accessible to the operator without a PIN access code. ‘Technician
Setup’ is not covered by this manual.
Use the 4-way switch to navigate the menu. Each menu screen indicates which keys to press to make the settings.
The instrument will default back to the main operating display after 30 seconds if no other key is pressed
Here is a summary of the display menu;
NOTE:
There are additional sequences selectable in the Operator Setup menu but not shown in the table. These sequences are
for wrapper models to which this manual does not apply.
Please refer to section 3 for further explanation of the Operator Setup functions given in the table above.
Default
Function Menu
no.
404EH
280 ARC
580A 1080A
Range
Contrast 4.01 6
6
6
0-12
Film Break
4.02
OFF
OFF
OFF
ON/OFF
Remote Type
4.41
RF
RF
RF
RF/IR
Squeeze
IN
4.07
0.0
0.0 0.0 0-9.9
Load UP
4.08
0.0
0.0
0.0
0-9.9
Squeeze OUT
4.09
0.0
0.0
0.0
0-9.9
Load down
pause
4.10
0.0
0.0
0.0
0-9.9
Tip UP
4.17
4.0
4.0
4.0
0-9.9
Tip UP to tip
DOWN
4.18
0.3
0.3 0.3 0-9.9
Tip
down
4.19
4.8
4.8 4.8 0-9.9
Fast Last rev
4.20
1.2
1.2
1.2
1.2
Load down time
4.30
0.0
0.0
0.0
0-9.9
¼ turn
4.45
OFF
OFF
OFF
ON/OFF
Language 4.35
English English
English E/F/D/NL/DK
