Tanco Autowrap 404 EH, Operator'S Handbook Manual

20 

Tanco Autowrap 404 EH 

Operators manual  

 
The default settings for the machine are developed by Tanco for optimal operation of the machine. However, the 
operator can change certain parameters in the ‘Operator Setup’ menu to take account of operational conditions. 

Parameter Default 

Application  Description 

‘Film Break’

OFF

ARC machines

If sensor is fitted and selected the cycle is interrupted if 
there is a film break

Remote Type 

RF 

All 

Select type of remote control 

‘Squeeze IN’

0.0s

1080

The time period required for the gripper arm to grip the 
bale sufficiently. 

Increase setting if the bale grip is insufficient. 

‘Load UP’ 

5.0s 

580A 
AUTOLOAD 

1080A 
AUTOLOAD 

The time period required for the load arm to reach the 
point at which the bale transfers onto the table. 
Adjustment may be required to set the optimum stopping 
point. 

If bale transfer is inconsistent, then increase setting to 
raise the stopping point 

‘Squeeze OUT’ 

3.0s 

1080A 
AUTOLOAD only 

The time period required for the gripper arm to release 
the bale. 

Increase setting if the bale gripper arm does not extend 
sufficiently. 

‘Load down 

pause’

0.0

All

Time after load arm sensor is active before stops.

‘Tip up’

4.0s

All

The time period required for table to tip up.  Increase 
setting if the bale is not tipped off the table. 

‘Tip up to down’ 

0.3s 

All 

The time period tip up to tip down. 

May be increase if you require more time for the bale to 
drop before tip down commences 

‘Tip down’ 

4.8s 

All  

The pause duration after the load arm reaches its 
uppermost position, to allow for the bale to transfer onto 
the table rollers. Adjustment may be required depending 
on the size/type of bale. 

Increase setting if the bale does not transfer in sufficient 
time. 

‘Fast Last Rev’ 

1.2 

All 

Time on last rev before turntable goes to slow speed. 

‘Tip UP’ 

4.0s 

All 

The time period required for the table to descend to the 
horizontal position. 

Increase setting if the table does not return to down 
position. 

¼ 

Turn 

OFF ARC 

machines Select 

if you want turntable to turn 90

o

 after Tip 

8.3 Operator Setup Menu