12
20/03/2015
Tanco Autowrap 404
Operators manual
6.0
ADJUSTMENT /
OPERATING.
6.1
SUPPORT ROLLERS.
Place the bale you want to wrap on top of the rollers. Move the support rollers as tight to the bale
as possible. Make sure that the bale is in center of the rollers.
6.2
HEIGHT ADJUSTMENT OF
DISPENSER.
The Dispenser can be placed in different positions. Disconnect the locking bolt, and adjust the
pre-stretcher so that the plastic hits in the middle of the bale. Replace the locking bolt and the
splint.
6.3
Operating Lykketronic control box
See chapter 8
6.4
REVOLUTION SPEED OF TURNTABLE.
Start the machine by operating the lever inside the tractor. The speed of the turntable is adjusted
by the speed of the tractor engine or how much you move the lever. Adjust this until the turntable
speed is approx. 22 revolutions per minute (Just below 3 seconds per revolution).
The machine
can
also be equipped with a control valve that makes it easier to adjust the speed.
Then you can have full opening of the lever and adjust the oil-flow to the machine, and by that
adjust the speed of the turntable. This valve is extra equipment.
6.5
OVERLAP.
To control the overlap, stop the machine after a few turns. Use a marker to mark a line on the
middle of the film wrapped on the bale. By the next turn this line should just be covered. It is now
possible to use ether the 500mm or the 250mm film on the MINI WRAP 404EH. The machine is
prepared for use with the 500mm film, when using 250mm film the chains from the turntables
main shaft must be lengthened with the enclosed chain pieces and moved to the largest chain
wheels. For 360 mm film special sprockets must be ordered. Contact you local dealer for details.
