Administrator Settings
189
4.8.1
ISDN/External/Leased E1/T1
Network
Type
Before using the system it is necessary to specify which network to use and
define its settings.
ISDN-
BRI
If you want to use your system via ISDN-BRI, you should select Network Type:
ISDN-BRI and enter the ISDN BRI Settings menu to set the BRI parameters.
ISDN-
PRI*
If you want to use your system via ISDN-PRI, you should select Network Type:
ISDN-PRI and enter the ISDN PRI Settings menu to set the PRI parameters.
Leased
E1/T1*
If you want to use your system via Leased E1/T1, you should select Network
Type: Leased E1/T1 and enter the Leased E1/T1 Settings (see
Leased E1/T1
Settings
) menu to set the Leased E1/T1 parameters.
External
If you want to use special networks and connect using RS449, V.35, X.21 or
connect to ISDN via an external IMUX, you should select Network Type: External
and enter the External Network Settings (see
External Network Settings
menu to
set the External Network parameters.
*
Note that both Leased E1/T1 and ISDN-PRI uses the same interface on the codec marked
E1/T1.
Summary of Contents for 700 MXP
