Tandberg C Series Reference Guide
Verify that the power cable
is
plugged into the power outlet in the
wall.
Verify that the network cable
is
plugged into the network outlet in the
wall. The network cable must be
plugged into the OTN-dedicated
network outlet.
Verify that the Power Bar
is turned
On
– The power bar supplies the whole
system
– you can turn off your system
here at the end of your session.
Verify that the monitor is on.
If you
cannot see the camera view, you may
have to switch the video source at the
top to the remote control to the main
camer
a input. Press the green Call
button to connect.
Verify that the codec/camera is on
by checking the switch at the back left
of the codec
Pick up the remote control
which
should be found in the basket.
Unmute your videoconferencing sound
by pressing the “Mic Off” button on the
remote control.
OTN SERVICE DESK 1-866-454-6861
1
2
3
4
5
6
2.2 | OTN Training Services