TANDBERG
CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction
Installation
Quick Setup
Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006
The Content Server will always be turned on and be
available to record conference calls.
The physical unit should not be accessible to users.
If the system does not respond:
Check the LCD panel to determine if the unit is
switched on and ‘live’
Make sure that the Content Server is switched on by
using the On/Off switch located at the rear of the unit
Restart the Content Server using the LCD panel.
or,
Restart the TCS service on the Content Server (this
will only affect the calls which are live at the time of
the restart, but will not affect any users accessing
recorded content on the server).
•
•
•
•
No System Response?
Do Not Shutdown or Restart While Calls Are In Progress!
We do not recommend to shutdown or restart the Content Server while calls are in progress. If the
Content Server is in a call and the server is restarted or shut down, calls in progress will fail and
will not be recorded.
The LCD panel display indicates the current status of the Content Server.
<IP Address>
NOT IN CALL
<IP Address>
IN CALL
LCD panel display when a call is currently in progress.
LCD panel display when no calls are currently in progress.
Restarting the Content Server
Press
Enter
to display the
Main Menu
screen
From the
Main Menu
screen, use the
Up
or
Down
arrow
to select
Commands
Press
Enter
to confirm your selection
From the
Commands
menu, use the
Up
or
Down
arrow
to select
Restart
and press
Enter
You will be asked to confirm this action on the following
screen. At the
Restart?
prompt, use the
Up
or
Down
arrow to select
Yes
and press
Enter
to confirm.
For an overview of the Command Menu Structure – see
below left.
1.
.
.
.
.
Shutting Down the Content Server
Press
Enter
to display the
Main Menu
screen
From the
Main Menu
screen, use the
Up
or Down arrow to select
Commands
Press Enter to confirm your selection
From the
Commands
menu, use the
Up
or
Down
arrow to select
Shutdown
and press
Enter
You will be asked to confirm this action on the following screen. At the
Shutdown?
prompt, use the
Up
or
Down
arrow to select
Yes
and
press
Enter
to confirm.
For an overview of the Command Menu Structure – see below left.
1.
.
.
.
.
There is currently no indication on the LCD panel to tell the
administrator that the machine has shut down and that it is safe
to turn off the server. Typically the server is in a state that it is
safe to shutdown within a few minutes.
Command Menu Structure
Restoring Factory
Settings is described on
the next page.
IP Settings
are treated in
Installation
.
IP Settings
Commands
Restart?
No
Yes
Shutdown?
No
Yes
- Restore Factory -
Full Restore
Config Restore
Full Restore?
No
Yes
Config Restore?
No
Yes
How to use the front panel keys is explained on the
next page.
For details on how to restart the TCS service
without restarting the Content Server, see the
Administrator Settings
section.
!
Shutdown and Restart
Basic Operating Principles