Instruction Manual: evolution 5000 E5710 and E5720 Encoder
Page 2-1
ST.TM.E10074.1
Chapter 2
2.
Installing the Equipment
Contents
2.1 Introduction ............................................................... 2-3
2.1.1 Read This First! ............................................ 2-3
2.1.2 General......................................................... 2-3
2.1.3 Site Requirements ........................................ 2-3
Power Supplies............................................. 2-3
Environment.................................................. 2-3
Lightning Protection...................................... 2-3
2.1.4 EMC Compliance Statements....................... 2-3
EN 55022 / AS/NZS 3548............................. 2-3
FCC .............................................................. 2-4
2.2 Preliminary Checks ................................................... 2-4
2.2.1 Mechanical Inspection .................................. 2-4
2.2.2 Moving the Equipment Safely....................... 2-4
2.3 Installing the Equipment............................................ 2-4
2.3.1 Fixing Method ............................................... 2-4
2.3.2 Cable Routing............................................... 2-5
2.3.3 Equipment Access........................................ 2-5
2.3.4 Ventilation..................................................... 2-5
2.4 AC Mains Operating Voltage and Earthing ............... 2-6
2.4.1 AC Power Supply.......................................... 2-6
2.4.2 Power Cable and Earthing............................ 2-7
General......................................................... 2-7
Protective Earth/Technical Earth .................. 2-7
Connecting the Encoder to the AC Power
Supply........................................................... 2-8
2.5 Signal Connections For the Basic Unit...................... 2-8
2.5.1 Introduction................................................... 2-8
2.5.2 Connecting Up the Basic Encoder................ 2-9
2.5.3 Power Supply.............................................. 2-10
2.5.4 Technical Earth........................................... 2-10
2.5.5 Video Inputs ................................................2-10
SDI IN..........................................................2-10
H SYNC.......................................................2-10
COMP VIDEO .............................................2-11
2.5.6 Audio Inputs ................................................2-11
2.5.7 ASI OUT 1, 2 and 3 Outputs .......................2-12
2.5.8 Control Interfaces........................................2-12
Connection ..................................................2-12
Ethernet #1 and #2......................................2-12
Alarm...........................................................2-13
Remote Control ...........................................2-13
2.5.9 Data.............................................................2-14
RS-232 Connector.......................................2-14
RS-422 Connector.......................................2-15
2.6 Powering Up/Down..................................................2-15
2.6.1 Before Powering Up ....................................2-15
2.6.2 Powering Up................................................2-16
2.6.3 Powering Down ...........................................2-16
2.7 Setting up the Encoder for Reflex Operation...........2-16
2.7.1 Overview .....................................................2-16
2.8 Setting the Encoder IP Address...............................2-17
2.8.1 Methods of Changing the Encoder IP
Address .......................................................2-17
2.8.2 From the Front Panel Menus ......................2-17
2.8.3 Via Telnet ....................................................2-17