Installing the Equipment
Page 2-14
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Table 2.9: Remote Control Connector (RS-232/ RS-485)
Remote (DTE)
Encoder (DTE) Remote Control
Signal Name
Signal Direction
Pin
Signal Name
1
Not connected
Transmit Data
2
Received Data (RS-232)
Received Data
3
Transmit Data (RS-232)
4
Not connected
Signal Ground
5
Signal Ground
Transmit Data B
6
Received Data B (RS-485)
Received Data A
7
Transmit Data A (RS-485)
Received Data B
8
Transmit Data B (RS-485)
Transmit Data A
9
Received Data A (RS-485)
NOTES…
1.
Signal names are with respect to a DTE in accordance with the RS-232 and RS-485
specification. A is positive and B is negative.
2.
A null modem connection must be used when connecting DTE together.
2.5.9
Data
RS-232 Connector
RS-232 is not currently supported in Build version 2.0.0 on the Base Board
but is supported in the option module M2/EOM2/DAT.
Table 2.10: RS-232 Data Connector (Base Board) - Asynchronous
Remote (DTE) Male
Encoder RS-232 (DTE) Female
Signal Name
Pin
Signal Direction
Pin
Signal Name
1
1
Not connected
Received Data
2
2
Received Data
Transmit Data
3
3
Transmit Data
4
4
Not connected
Signal Ground
5
5
Signal Ground
6
6
Not connected
7
7
Not connected
8
8
Not connected
9
9
Not connected
NOTES…
1.
Signal names are with respect to a DTE in accordance with the RS-232 specification.
2.
Remote pin numbers only apply to a 9-way D-type connector.
3.
25-way connectors have Received Data on pin 3 and Transmit Data on pin 2 (see RS –232
specification).
4.
XON/OFF flow control may be used with this port.
