TANDBERG 8000 MXP
164
Parallel dial: Channels will be dialed and connected in parallel when setting up a bonding
call.
PC PresenterTF: An easily accessible PC connection plug. When connected the PC image is
displayed on the monitor.
PC SoftPresenterTF: Shows PC images via the LAN connection.
PIP: Picture-In-Picture
point-to-point call: A call with two participants including your self
POP: Picture Outside Picture. POP is a picture layout mode that is optimized for wide
screens: Full screen, 1+3 layout and emulated dual monitor layout.
Presentation: Presentation means to show another video source. Use the Presentation Key
for a predefined presentation source. Use the presentation menu to choose among all
available video sources.
Presentation source: The video source that is on display when you press the Presentation
Key on the remote control
Presets: Predefined camera positions (and video sources)
Q
QCIF: Quarter CIF, 176x144 pixels
QSIF: Quarter SIF, 176x120 pixels
R
Release Floor: To end the request floor function.
release floor to site: Allows the chairman to release the floor.
Remote: Short for Remote Control
Request Floor: The MCU will broadcast the video in full screen to all other participants in the
conference. If the MCU conference has a chairman, a request will be sent to the the
chairman.
Restart: Restarts the system.
Restore defaults: Restores system settings to the factory defaults.
Restricted call: A call to a 56 kbps network. By default the system will dial an unrestricted
call (a call to a 64 kbps network) and downspeed to 56 kbps if necessary.
S
S-VHS: S-video
S-video: The standard camera uses one of the S-video inputs in the codec.
Selfview: Outgoing video. In most cases, the image of your self.
Side-by-Side: Side-by-side view means that two pictures are displayed side by side each
other on the screen. You will se two equally sized pictures.
SIF: Standard Input Format, 352x240 pixels
SNMP: Simple Network Management Protocol.
SNMP Community: SNMP Community names are used to authenticate SNMP requests.
SNMP requests must have a password in order to receive a response from the SNMP
agent in the system. The SNMP Community name is case sensitive.
SNMP Trap Host: Identifies the IP-address of the SNMP manager.
Summary of Contents for F1 D13353.02
Page 5: ...Table Of Contents v Glossary 159...
Page 6: ......
Page 18: ...TANDBERG 8000 MXP 12...
Page 162: ...TANDBERG 8000 MXP 156 6 13 Appendix 13 Declaration of Conformity...