Installing the Equipment
Reference Guide: SM6610, SM6615, SM6620 and SM6625 Satellite Modulators
Page 2-5
ST.RE.E10152.2
2.1.8
Installing Cables - Safety
Power supply cables should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them. Pay particular
attention to cables at plugs, convenience receptacles, and the point where
they exit from the appliance.
Do not run ac power cables in the same duct as signal leads. Do not move
or install equipment whilst it is still attached to the mains supply. Ensure
safety and ESD precautions are observed whilst inter-connecting
equipment.
2.1.9 Lightning
Protection
WARNING...
IF THE MODULATOR HAS BEEN SUBJECT TO A LIGHTNING STRIKE OR POWER SURGE WHICH
HAS STOPPED IT WORKING, DISCONNECT THE POWER IMMEDIATELY. DO NOT REAPPLY
POWER UNTIL IT HAS BEEN CHECKED FOR SAFETY. IF IN DOUBT, CONTACT TANDBERG
TELEVISION CUSTOMER SERVICES.
Where appropriate, ensure this product has an adequate level of lightning
protection. Alternatively, during a lightning storm or when it is left
unattended and unused for long periods of time, unplug it from the supply
outlet and disconnect the antenna or cable system. This will prevent
damage to the product due to lightning and power line surges.
2.2
EMC Compliance Statements
1
2.2.1
EN 55022
This is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
2.2.2 FCC
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
1
The EMC information was correct at the time of manufacture. The EMC tests were performed with the Technical Earth
attached.
