300109-16
TC36.NGST03.C
5056.42801.C3
3
Black Diamond Burner Installation
NOTE: For the purposes of these
instructions the controls and gas
connections are on the right hand
side of the unit.
Remove porcelain panels if they
are installed.
1. Position the air channel insert into
the air channel. (Fig. #2)
2. Remove the panel retainer clip
located on the upper heat shield,
install the left panel securing with
panel retainer clip previously
removed.
(Fig. #3)
3. Attach the manifold assembly to the
floor of the firebox using two screws.
Seal the remaining holes in the floor
of the fireplace with screws. (Fig. #4).
4. Connect the manifold flex gas line
and pilot flex gas line to the bulkhead
ensuring a gas-tight connection.
Fig. # 2
Fig. # 3
Fig. # 4
