082406-40
TC36.CSTE 15
1/4"
1"
MAX
Vent System
Town &
Components Country
12" Pipe Length ........................... TCVT.811X12
18" Pipe Length ........................... TCVT.811X18
24" Pipe Length ........................... TCVT.811X24
48" Pipe Length ........................... TCVT.811X48
12" Adjustable Pipe Extension .... TCVT.811X12ADJ
45° Elbow .................................... TCVT.811XLB45
90° Elbow .................................... TCVT.811XLB90
Wall/Offset Support ..................... TCVT.811XOS
Wall Termination Kit .................... TCVT.WTA
Roof Termination Kit .................... TCVT.RTA
Wall Shield/Ceiling Firestop ......... TCVT.THIMA
Roof Flashing, Adjustable ............ TCVT.811FLADJ
Roof Flashing, Flat ...................... TCVT.811FLFLT
Roof Flashing, Steep ................... TCVT.811FLSTP
or any that fi ts 11" pipe
Fig. # 35
WINDOW
FRAME
HEARTH
EXTENSION
WINDOW
TRACK
SUB-
FLOOR
Fig. # 34
HEARTH EXTENSION
While a hearth extension is not required
for this fi replace, one is recommended for
aesthetic reasons. The hearth extension
should be non-combustible and must not
be any more than 1" above the bottom of
the fi replace. If thicker, fi replace must be
raised up accordingly.
Caution: Hearth extensions thicker than
1" will interfere with the window frame.
VENTING
Before installing venting for this unit, the installer should read
these instructions to insure that the proper vent confi guration
has been selected.
Use only Town and Country Termination kits #:
TCVT.WTA - Wall Termination Kit
TCVT.RTA - Roof Termination Kit
Vent system components approved for use with the Town and
Country Fireplace are shown in Figure #35.
Various combinations of vertical and horizontal runs may be
used. Refer to Figure # 39 and 40 for details. For optimum
performance and fl ame appearance, keep the vent length
to a minimum and limit the number of elbows. Connections
between each vent system component must be tightly joined,
secured with sheet metal screws and sealed. A horizontal run
of vent should have a 1/4" rise for every 1 ft. of run towards
the termination.
CAUTION: UNDER NO CONDITION SHOULD COMBUS-
TIBLE MATERIAL BE CLOSER THAN 1 3/4 INCHES FROM
THE SIDES AND BOTTOM AND 1 3/4 INCHES FROM
THE TOP OF A HORIZONTAL SECTIONS OF THE VENT
PIPE AND 1 3/4 INCHES FROM A VERTICAL SECTION
OF PIPE.
Summary of Contents for TC36ST
Page 38: ...38 TC36 CSTE 082406 40 NOTES...
Page 39: ...082406 40 TC36 CSTE 39 NOTES...