6 TC36.CSTE
082406-40
INSTALLATION REQUIREMENTS
The Town & Country Fireplace installation and venting must
conform to the current CAN/CGA-B149 installation code (in
Canada) or the current National Fuel Gas Code, ANSI Z223.1
(in the USA), and approved per local codes. Only qualifi ed
(licensed or trained) personnel should install this product.
In the state of Massachusetts, only a licensed Plumber
and Gas Fitter may install this product.
Fig. # 4
Fig. # 5
EXAMPLES OF COMMON LOCATIONS
TOP STANDOFFS
The top standoffs are shipped loose inside the fi replace and
must be installed on top of the fi replace as shown in Fig. # 4.
Assembly:
1) Remove the standoffs from inside the fi replace.
2) Position the standoffs in place and secure with screws
provided.
LOCATING THE FIREPLACE
In planning the installation for the fi replace, it is necessary to
determine where the unit is to be installed, location of vent
system and where gas supply piping may be plumbed. Vari-
ous installations are possible, such as, into an existing wall,
a built-in wall, peninsula or a partition wall (see Fig. #5). Due
to high temperatures, do not locate this fi replace in areas of
high traffi c or near furniture or draperies.
The minimum clearances from the fi replace to combustible
surfaces must be adhered to and are shown on Fig. # 2
and #3.
CAUTION:
When selecting a location, ensure
that there is adequate room on the side of the
fi replace for the control box.
TOP STANDOFFS
SEE FIG #9 FOR
DIMENSIONS
SEE FIG. # 9
FOR DIMENSIONS
Summary of Contents for TC36ST
Page 38: ...38 TC36 CSTE 082406 40 NOTES...
Page 39: ...082406 40 TC36 CSTE 39 NOTES...