page 22 TC42_B2
230905-36
BRICK PANELS INSTALLATION
(HERRINGBONE ................. TCPN.547)
(TUSCAN ............................. TCPN.548)
(HERITAGE RED ................. TCPN.552)
For porcelain panel kit (TCPN.549) installation see instruc-
tions provided with panel kit.
A Firebox Panel Set has to be installed for safe operation.
Do not use the fi replace without panels Unpack and inspect
all panels. The panels need to be installed before the logs
are in place.
Caution:
The Brick Panels are very fragile, and should be
handled with care.
1) Remove the Side Panel Retainers located on the underside
of the upper fi rebox heatshield. The retainers are each
held in place by one screw.
2) Install the Lower Rear Panel.
3) Install the Left Side Panel by inserting the bottom of the
panel in fi rst and then angling it up into position. It may
be necessary to push the upper fi rebox shield up to allow
panel to move freely into place.
4) Install the Right Side Panel using the same technique as
the left.
The rear panel is held tight against the side panels by two "V"
brackets located on the fi rebox rear wall. Although the brackets
are adjusted at the factory for the best fi t, some adjustment
Fig. # 30
Fig. # 29
LEFT SIDE
PANEL
RIGHT SIDE
PANEL
REAR UPPER
PANEL
REAR LOWER
PANEL
LEFT FRONT
PANEL
RIGHT FRONT
PANEL
REAR LOWER PANEL
ADJUSTABLE "V" BRACKET
may be necessary. Adjust the angle of the bracket by hand
to ensure a snug fi t.
5) Install the Rear Upper Panel.
6) Re-install the Side Panel Retainers.
7) Install the Left and Right Front Panels.
HERRINGBONE PANEL SET SHOWN
