TCWS.54NG04.C 180208-12
10 Place the front pebble cluster over
the burner. Use the pins on the burner
and holes in the pebble cluster to locate
the pebbles on the burner. (Fig. #10)
11 Place the top rocks on top of the
pebble clusters as shown. Use the slots
in the top rock to align to the tabs on the
pebble clusters. (Fig. #11 & below)
12 Repeat the sequence of placing
the front, rear and top rocks three more
times until the burner is covered.
13 Place equalizer rocks either end
of burner as shown. (Fig. #12)
14 Install front porcelain cover (wide
edge should face the front). (Fig. #13
& #13A)
REAR CLUSTER
FRONT CLUSTER
SLOPE INTO
THE CLUSTER
WIDE SECTION
TO FRONT
WIDE EDGE TO FRONT OF
FIREPLACE
Fig #10
Fig #11
Fig #12
Fig #13
Fig #13A
5
