43
⑧
④
③
②
①
⑤
⑦
⑥
①
Recording Status:
…
Recording
…
Stopped
②
Recording Interval:10 min
③
Recording Mode:
…
One Time
…
Endless
④
Battery Life
⑤
Communication Date and Time
⑥
Group Name
⑦
Remote Unit Name
⑧
Measurement at Time of
Communication
Remote Unit Conditions Display
You can check selected Remote Unit info (Recording Conditions,
Current Measurements, and Battery Life, etc.)
②
Select the unit you wish
to view.
①
Select the group in which
the unit is registered.
※
Before selecting a Remote Unit you can run a search to find all Remote Units
with which communication is possible.Those units with which communication is
possible will appear with a mark next to them. (See p.45 for details)
1
.
In the Main Menu, open [ Gather Data] .
2
.
Select the Remote Unit you wish to view.
3
.
Click [ Get Rmote Info] .
4
.
Once communication has been completed, the Remote Unit info
will be displayed.
44
●
If upper and lower limits have been set a
▼
will appear in the lower left
corner of the display. By turning the operation dial you can view the limit
settings and the judgment results.
【
For RVR-52 Pulse Recording
】
【
If RVR-52 has been set for Event Recording Mode
】
If no event data has been recorded,
[No Event Data] will appear.
Recording Signal Condition
●
The total number of pulse readings during the recording interval set when
recording settings were made for the Remote Unit will be displayed.
・
Rising Edge (OFF
→
ON) :
・
Falling Edge (ON
→
OFF) :
# of Pulses / Recording Interval